Halslab Proton Pack Volt Meter Mod

This volt meter mod is to monitor the voltage at your proton pack through the motherboard board connectors. Simply unplug the switch connector on the motherboard and install the volt meters jumper harness in between. Then attach the volt meter above the power cell with the supplied Velcro and route the cables through the storage compartment.

This mod does nothing else but display circuit board voltage and adds a custom look to your proton pack, such as Egon would have potentially created.

auto on-1.jpg
auto on-2.jpg
auto on-3.jpg
auto on-4.jpg

----DISCLAIMER PLEASE READ----

  • Please note, you will need to take apart the proton pack in order to replace the factory plastic frosted white lens for the blue acrylic lens and battery installation modifications. Some skill and mechanical knowledge of the pack is required.

  • This blue acrylic lens is designed to be a direct fit without cutting the proton pack. However, due to tolerance differences in the Hasbro manufacturing process, you may need to slight trim or sand the lens to fit between the locating tabs.

  • I assume no responsibility for any possible damage during disassembly, during modifications or if parts are installed incorrectly.

  • Wiring harness was tested before shipping to ensure it functions properly.

  • You will need to peel the protective covering off the blue acrylic when you get it.