Important Information About Attenuator 2.0

Attenuator 2.0 was designed to be universal and is compatible with both the STOCK electronics Haslab proton packs and the Ninjatunes electronics upgraded Haslab proton packs. However, it is truly universal and could be adapted to other proton pack kits with some adaptation by the end user.

Attenuator 2.0 is available in 4 different kit variants.

1. Complete with venting kit

2. Complete without venting kit

3. Build your own with venting kit

4. Build your own without venting kit

Depending on which kit variant you purchase, you may not use all wire connections or included parts, but parts are still included for future use or future adaptations.

When attenuator 2.0 is installed on a STOCK electronics Haslab proton pack, it will function as a keep alive kit for the pack only and keep the pack running indefinitely.

IMPORTANT: Attenuator 2.0 is not designed to work with other keep alive mods for the pack or wand and is not recommended to be used with them. I assume no liability for adverse effects, damage or unintended outcomes due to experimentation of Attenuator 2.0 with other electronic pack modifications.

Attenuator 2.0 is designed to run on 5 volts only. DO NOT run power greater than 5 volts or damage to the electronics will occur.

The venting control module is just a simple relay and the output acts as a switch. The wiring output in the kit is made specifically for the Haslab and Ninjatunes boards. If you want to use Attenuator 2.0 on a different kit, you can replace the output wiring of the relay with a standard two wire connector.

Connection from the Attenuator 2.0 to the Proton Pack uses a 4 pin GX16 connector and cable set up, commonly called an “Aviation Cable” and is listed as such throughout the instructions.

On Ninjatunes, if  your wand is on, manual venting is not possible. This is because of the programming of the Ninjatunes board, it will override manual venting when it senses the wand is active in preparation for overheat venting of the wand.